Mikrotron MC13xx Manuál s instrukcemi stáhnout pdf (Strana 11)

4 Operating Modes

By means of the MotionBLITZ®Kit software (control program) the camera can be set up for recording

in different operating modes.

4.1 Live mode

The camera images are continuously recorded and displayed. This mode is optimal for defining image

detail, adjusting the focus and setting up the variuos camera parameters. Switch the camera to live mode

by pressing the "Live" button.The framestamp will be displayed on the Infoline

4.2 Prepare for recording

The camera parameters are adjusted according to the users needs after the camera is connected to the

PC.

4.3 Start recording on onboard memory

After power up, the camera starts with the last used settings. If you need another resolution/frame

speed, the new parameters must be entered via the MotionBLITZ®Kit control software.

To start recording press the red start recording button in the MotionBLITZ®Director pro-

gram or use trigger-0 input.(see to page 16, Start record- ing)

Inspecta-5 holds 1 Gbyte internal frame memory. From this memory, a very small part (only as much as

required by one frame) is used for storing the frames for the live mode. All of the remaining memory is

used for sequence recording.

4.3.1 Non circular mode

The camera stops recording when the internal frame buffer is full.

4.3.2 Circular recording mode

The camera records frames in a circular mode (i.e. the oldest frames are always overwritten by the new-

est) and waits for a signal to stop. Similar to the “Live” mode, there are 2 methods to stop recording:

apply a trigger signal (rising or falling edge, depends on setting “Trigge edge” in form “Camera

Setup”) to the appropriate camera input connector

press the Stop button in the MotionBLITZ®Kit control program

MotionBLITZ®Kit Manual Ver.2.0 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 50 51

Žádné komentáře

Mikrotron MC13xx Manuál s instrukcemi Strana 11